Solberg Vacuum Discharge Oil Mist Eliminators Manuel d'utilisateur télécharger pdf (Page 9)

Solberg International, Ltd., 1151 Ardmore Itasca, IL 60143 USA

Ph: +1 630.773.1363 • Fax: +1 630.773.2643 • Email: sales@solbergmfg.com • Web: www.solbergmfg.com

Oil Mist Exhaust Filters • Rev. MA4031103

Page 9

SOLBERG

C. Secure washer and thumb/wing/hex bolt to element top plate and tap bolt.

Element must be tightly secured. Note: Do NOT over tighten!

! WARNING !

Defective installation may cause system or

pump contamination. Use only genuine

Solberg replacement parts.

5. Securing canister/housing top to canister base.

A. Make sure all surfaces are free from dust and other particulate.

B. O-rings (where necessary) must rest evenly along canister/housing base o-ring

groove.

C. SV: Place canister top over element and twist top.

D. EF/EE: Place canisters top over element and insert and tighten thumbscrew.

E. Small HDL (2”-2 ½”): Secure V-clamp by disconnecting hex nut or T-bolt portion

and placing V-clamp along the diameter of canister o-ring groove. Fasten T-bolt

and secure tightly. V-CLAMP LEGS MUST REST UNIFORMLY ALONG ENTIRE

O-RING GROOVE. For smaller EE’s, simply twist canister top until top is in

resting position with tabs.

F. Large HDL: Replace housing top plate. Insert T-bolts into corresponding holes

and tighten evenly around perimeter. Note: Do NOT over tighten!

Section D

MAINTENANCE RECOMMENDATIONS

1. Initial back pressure readings are recommended to maintain an effective oil mist filter.

Always document initial back pressure during start-up when element is clean and

after two weeks when element is saturated. Replacement cartridge is needed when

system experiences high back pressure. Refer to page 6 for guidelines.

2. Always check replacement O-rings to insure they are seated uniformly along the

canisters/housings during installation. If O-rings do not seat properly or are damaged

in some manner, contact Solberg Manufacturing, Inc. immediately. Do not modify or

change O-rings!

1 2 3 4 5 6 7 8 9 10

Pas de commentaire

Solberg Vacuum Discharge Oil Mist Eliminators Manuel d'utilisateur Page 9